Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
639
no vrrp priority
Description
With this command, you reset the router priority back to the default value.
Note
This command is available only with
layer 3.
● An IPv4 address is assigned to the virtual router.
● You are in the VRRP Interface configuration mode
.The command prompt is:
cli(config-vrrp-if)#
Call up the command with the following parameters:
no vrrp <vrid(1-255)> priority
The parameters have the following meaning:
The priority is reset.
You configure a VRRP interface with the interface command.
You create the priority with the
vrrp priority command.
You assign IPv4 addresses to a virtual router with the
vrrp associated-ip command.
You display the priority with the
show vrrp interface - vrid command.
To Next Page
Loading...
Need help?
General