Siemens SCALANCE XM-400 Configuration Manual

System time
5.3 SNTP Client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
171
Parameter
Description
Range of values / note
FQDN
Domain name (Fully Qualified Domain
Name)
Maximum of 100 characters
ipv6
Keyword for an IPv6 address -
ip6_addr
Value for the IPv6 address of the time
server
Enter a valid IPv6 address.
port
UDP port of the time server 1025 … 36564
Default: 123
poll
Keyword for the time after which the
time of day is requested again
-
seconds
Value for the time in seconds
16 ... 16284
secondary
Keyword to store the second SNTP
server
If you do not specify this parame-
ter, the first SNTP server is
stored.
Result
The SNTP unicast server is configured.
Further notes
You can reset the setting to the default with the no sntp unicast-server command.
You display this setting and other information with the
show sntp unicast–mode status
command.
5.3.3.4
no sntp unicast-server
Description
With this command, you delete the attributes for an SNTP unicast server and reset the
address.
Requirement
You are in the SNTP configuration mode.
The command prompt is as follows:
cli(config-sntp)#
Syntax
Call up the command with the following parameters:
no sntp unicast-server {ipv4 <ucast_addr> | fqdn-name <Fully Qualified Domain
Name(100)> | ipv6 <ip6_addr>}

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English