Configuration
3.5 PoE
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
130 Configuration Manual, 06/2016, C79000-G8976-C252-11
The user-defined power is compared to the range of values of the class indicated by the
connected device.
● If the user-defined power is within the class of the connected device, the user-defined
value is used.
● If the user-defined power is above the class of the connected device, the highest value of
the class is used.
● If the user-defined power is below the class of the connected device, the lowest value of
the class is used.
If the value used is exceeded, the device is turned off.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
poe pse <integer(1-4)> MaximumPower <integer(1-90)>
The parameters have the following meaning:
Value for the maximum power in watts 1 ... 90
The value for the maximum power is configured.
You delete the value for the parameter "Maximum Power" with the no poe pse MaximumPower
command.
no poe pse MaximumPower
Description
With this command, you delete the value for the "Maximum Power" parameter.
To Next Page
Loading...
Need help?
General