SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
61
The following is described in this section:
● System settings
● Saving and loading configurations and firmware
This section describes commands with which general system properties can be displayed
and configured.
This section describes commands with which you display various settings.
show broadcast-block config
Description
This command shows the broadcast blocking settings for ports.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show broadcast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Keyword for a port description
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
To Next Page
Loading...
Need help?
General