Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
538 Configuration Manual, 06/2016, C79000-G8976-C252-11
Call up the command with the following parameters:
no default-information originate [(
[always]
[metric <metric-value (0-0xffffff)>]
[metric-type <type (1-2)>])]
The parameters have the following meaning:
The external standard route is always
Keyword for the metric of the external
standard route.
--
Keyword for the type of the external
--
Type of the external route
• 1 - type 1
External and internal costs
• 2 - type 2
The function is disabled.
You enable the function with the default-information originate command.
default-information originate always
Description
With this command, you enable the function with which a standard route is always generated
for external routes into the OSPF routing domain.
Note
This command is available only with layer 3.
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#