Siemens SCALANCE XM-400 Configuration Manual

SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
29
Introduction
1
1.1
Information on the configuration manual (CLI)
Validity of the configuration manual
This Configuration Manual covers the following products:
● SCALANCE XR-500
– SCALANCE XR524-8C
– SCALANCE XR526-8C
– SCALANCE XR528-6M
– SCALANCE XR552-12M
The devices are available with or without routing functions. For the devices without
routing functions, you can enable the functions with a KEY-PLUG.
● SCALANCE XM-400
– SCALANCE XM408-4C
– SCALANCE XM408-8C
– SCALANCE XM416-4C
The devices are available with or without routing functions. For the devices without
routing functions, you can enable the functions with a KEY-PLUG.
This Configuration Manual applies to the following software versions:
● SCALANCE XR-500 firmware as of version 6.0
● SCALANCE XM-400 firmware as of version 6.0
Purpose of the Configuration Manual
This Configuration Manual is intended to provide you with the information you require to
install, commission and operate IE switches. It provides you with the information you require
to configure the IE switches.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English