Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
68 Configuration Manual, 06/2016, C79000-G8976-C252-11
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show ip interface [Vlan<vlan-id(1-4094)>]
[<interface-type><interface-id>]
[loopback<loopback-id(0)>]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
Number of the addressed loopback
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the configuration is displayed for
all available IPv4 interfaces.
The configuration of the selected IPv4 interface is displayed.
show ipv6 interface
Description
This command shows the configuration of one, several or all IPv6 interfaces.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General