Siemens SCALANCE XM-400 - Show Ipv6 Ospf Redist-Config; Show Ipv6 Ospf Redundancy

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
573
Result
The information is displayed.
9.3.1.8
show ipv6 ospf redist-config
Description
This command shows the information that is distributed via the routes of the routing table.
Note
This command is available only with layer 3.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ipv6 ospf redist-config
Result
The information is displayed.
9.3.1.9
show ipv6 ospf redundancy
Description
This command shows OSPFv3 redundancy.
Note
This command is available only with layer 3.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#