Siemens SCALANCE XM-400 - No Ip Nat Service Portrange

Layer 3 functions
9.9 NAT (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
750 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.9.3.10
no ip nat service portrange
Description
With this command you delete static port translations (NAPT) for an interface with a port
range.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ip nat service portrange <inside local ip> {tcp|udp|any} <inside local start port
no> <inside local end port no>
The parameters have the following meaning:
Parameter
Description
Range of values / note
inside local ip
Actual address of the device that is
reachable from external.
Enter a valid IPv4 address.
Protocol Protocol for which the port translation
is valid.
•
tcp
•
udp
•
any
inside local start
port no
Start port that is assigned to the inside
local address.
-
inside local end
port no
End port that is assigned to the inside
local address.
-
Result
The static port translation with a port range is deleted.
Further notes
You configure static port translations for an interface with a port range with the ip nat
service portrange
command.
You configure static port translations with a service for an interface with the
ip nat service
command.
You display the current configuration with the
show ip nat service portrange command.