Diagnostics
12.1 Event and fault handling
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
902 Configuration Manual, 06/2016, C79000-G8976-C252-11
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Call up the command with the following parameters:
no power [{L1|L2}}
The parameters have the following meaning:
No monitoring of power supply 1
No monitoring of power supply 2
If you do not select any parameters from the parameter list, the default value "L1 and L2" is
used.
The setting for monitoring the power supplies is configured.
You can display the current setting with the show events faults config command.
You enable the function with the
power command.
With this command, you configure and enable the monitoring of the physical network
connections for cable breaks or for pulling of the connector.
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
To Next Page
Loading...
Need help?
General