Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
714 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call up the command with the following parameters:
no match destination ip <Ip address> <Net Mask>
The parameters have the following meaning:
Parameter
Description
Range of values / note
Ip address
IPv4 address Enter the IPv4 address of the destination on which the filter-
ing is based.
Net Mask
Subnet mask of the corresponding
subnet
Enter the subnet mask of the destination on which the filter-
ing is based.
Result
The filter for the destination IPv4 address is deleted.
Further notes
You create a filter for the destination IPv4 address with the match destination ip command.
You create a filter for the destination IPv6 address with the
match destination ipv6
command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
9.8.3.3
match destination ipv6
Description
With this command, you specify whether or not the routing information for a route map is
filtered based on the destination IPv6 address.
Note
This command is available only with layer 3 (IPv6).
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English