Siemens SCALANCE XM-400 - No Area Range

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
527
Parameter
Description
Range of values / note
notadvertise
The address range is not advertised to
the outside.
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The address range is configured.
Further notes
You delete the address range with the no area range command.
You can display the status of this function and other information with the
show ip ospf -
area-range / summary-address
command.
9.2.3.5
no area range
Description
With this command, you delete the address range.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
area <AreaId> range <Network> <Mask>