Network structures
6.2 Link aggregation
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
230 Configuration Manual, 06/2016, C79000-G8976-C252-11
The information is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
port-channel load-balance
Description
With this command, you configure the load balancing policy for the interconnected ports of
the previously defined port channels.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
port-channel load-balance
{mac-src-dst | ip-mac-src-dst}
[<port-channel-index(1-8)>]
The parameters have the following meaning:
Load balancing is based on the MAC
addresses of the sources and destina-
Default: enabled
Load balancing is based on the IP and
MAC addresses of the sources and
-
Number of the port channel
If you do not enter a value for port-channel-index, the setting is used for all port channels.
To Next Page
Loading...
Need help?
General