Siemens SCALANCE XM-400 - No Ip Nat; Ip Nat Timeout

Layer 3 functions
9.9 NAT (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
740 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.9.2.2
no ip nat
Description
With this command you disable NAT/NAPT for the entire device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip nat
Result
NAT/NAPT is disabled globally for the entire device.
Further notes
You enable NAT/NAPT for the entire device with the ip nat command.
You display the current configuration with the command.
9.9.2.3
ip nat timeout
Description
With this command you define periods of time after which existing connections are deleted if
there is no data exchange.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#