Security and authentication
11.7 Port-based Network Access Control (Dot1X)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
880 Configuration Manual, 06/2016, C79000-G8976-C252-11
Call up the command with the following parameters:
set dot1x mac-auth mac-addr count <num-of-addresses (1-100)>
The parameter has the following meaning:
Maximum number of devices
The maximum number of devices for the port has been specified.
You display this setting and other information with the
show dot1x command.
dot1x reauthentication
Description
With this command, you enable the 802.1x Re-Authentication function for the selected
interface. When the function is enabled, the authenticator repeats authentication of the client
periodically,
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameters:
dot1x reauthentication
Periodic authentication is enabled for the selected interface.
To Next Page
Loading...
