Siemens SCALANCE XM-400 - Nfc Active; No Nfc Active

Configuration
3.6 NFC (SCALANCE XM-400 only)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
141
3.6.2.1
nfc active
Description
With this command, you activate NFC.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
nfc active
Result
NFC is activated.
Further notes
You deactivate NFC with the no nfc active command.
You display the status, i.e. whether the NFC function is activated or deactivated with the
command
show nfc active status.
3.6.2.2
no nfc active
Description
With this command, you deactivate NFC.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no nfc active