Siemens SCALANCE XM-400 - Link Aggregation; The Show Commands; Show Etherchannel

Network structures
6.2 Link aggregation
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
227
Syntax
Call the command without parameters:
no transparent-vlan
Result
If the VLAN was configured as a transparent VLAN, this function is deactivated.
This means the following:
● All transparent ports become untagged members in this VLAN
● The port VLAN ID of the previous transparent ports remains set to the ID of this VLAN.
● All other ports remain marked as forbidden in this VLAN.
Further notes
You enable the setting with the transparent-vlan command.
6.2
Link aggregation
This section describes commands that configure or manage the bundling of interfaces or
connections between devices.
6.2.1
The "show" commands
This section describes commands with which you display various settings.
6.2.1.1
show etherchannel
Description
This command shows the settings of the Etherchannel.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#