Load control
10.3 Dynamic MAC aging
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
790 Configuration Manual, 06/2016, C79000-G8976-C252-11
Call up the command with the following parameters:
mac-address-table aging-time <seconds(10-630)>
The parameter has the following meaning:
Life of the entry in seconds 10 ... 630
The value of the aging of a dynamically learned entry is configured.
You can reset the setting to the default with the no mac-address-table aging-time command.
You display the setting with the
show mac-address-table aging-time command.
no mac-address-table aging-time
Description
With this command, you reset the value for the aging of a dynamically learned entry in the
MAC address list to the default value.
The default value is 40 s.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no mac-address-table aging-time
The value of the aging of a dynamically learned entry is reset to the default value.
To Next Page
Loading...
Need help?
General