Siemens SCALANCE XM-400 - HTTP Server; The Show Commands; Show Ip Http Server Status; Commands in the Global Configuration Mode

Network protocols
7.10 HTTP server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
420 Configuration Manual, 06/2016, C79000-G8976-C252-11
7.10
HTTP server
This section describes commands of the Hypertext Transfer Protocol (HTTP).
7.10.1
The "show" commands
This section describes commands with which you display various settings.
7.10.1.1
show ip http server status
Description
This command shows the status of the HTTP server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip http server status
Result
The status of the HTTP server is displayed.
7.10.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.