Siemens SCALANCE XM-400 - SNTP Client; The Show Commands; Show Sntp Status

System time
5.3 SNTP Client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
165
Requirement
You are in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
Syntax
Call up the command with the following parameters:
ntp time diff <(+/-hh:mm)>
The parameter has the following meaning:
Parameter
Description
+
Time zones to the west of the NTP server time zone
-
Time zones to the east of the NTP server time zone
hh
Number of hours difference
mm
Number of minutes difference
Enter the number of hours and number of minutes with two digits each.
Default: No time difference.
Result
The time difference between the device and the NTP server is configured.
5.3
SNTP Client
This section describes commands relevant for configuration of the SNTP client.
5.3.1
The "show" commands
This section describes commands with which you display various settings.
5.3.1.1
show sntp status
Description
This command shows the settings of the Simple Network Time Protocol.