Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
591
9.3.3.10
distribute-list
Description
This command enables the filtering of the routing information according to a route map for
incoming routing information.
Note
This command is available only with layer 3.
Requirement
● OSPFv3 routing is activated.
● The router is an ASBR router.
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
distribute-list route-map <name(20)> in
The parameters have the following meaning:
Parameter
Description
Range of values / note
route-map
Keyword for a route map
-
name
Name of the route map
Maximum of 20 characters
in
Incoming routing information is fil-
tered.
-
Result
The filtering is enabled.
Further notes
You disable the filtering with the no distribute-list command.
You enable OSPFv3 routing with the
ipv6 router ospf command.
You display the setting with the
show ipv6 ospf command.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English