Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.9 NAT (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
738 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The current NAT/NAPT configuration of the interfaces is displayed.
Further notes
You enable NAT for the selected IP interface with the ip nat command in the Interface
configuration mode.
You disable NAT for the selected IP interface with the
no ip nat command in the Interface
configuration mode.
You enable NAPT for the selected IP interface with the
ip nat napt command in the
Interface configuration mode.
You disable NAPT for the selected IP interface with the
no ip nat napt command in the
Interface configuration mode.
9.9.1.5
show ip nat
Description
This command shows address translations or active connections depending on the selected
parameter.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip nat { interface | static | translations}
The parameters have the following meaning:
Parameter
Description
Range of values / note
interface
Shows the configuration of the dynamic address
translations.
-
static
Shows the configuration of the static 1:1 address
translations.
-
translations
Displays the active NAT connections.
-
Result
The configured address translations or active connections are displayed.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English