Siemens SCALANCE XM-400 - Show Ip Pim Interface Detail

Layer 3 functions
9.10 PIM (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
754 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip pim rp-hash [<multicast_Group_address> <Group_mask>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
mul-
ticast_Group_addres
s
Address of the multicast group -
Group_mask
Subnet ma
sk that restricts the multicast
band
-
If no parameters are specified, the RPs of all multicast groups are displayed.
Result
The current rendezvous point of the multicast group is displayed.
Further notes
You define interfaces as candidates for rendezvous points with the command rp-candidate
rp-address
.
You configure a device as a static rendezvous point with the
ip pim static-rp command.
You specify the interfaces for static rendezvous points with the
rp-static rp-address
command.
9.10.1.2
show ip pim interface detail
Description
With this command, you display detailed settings for PIM.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#