To Next Page

To Previous Page

Functions specific to SCALANCE

4.1 PLUG

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

144 Configuration Manual, 06/2016, C79000-G8976-C252-11

4.1.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.

In Privileged EXEC mode, enter the

configure terminal command to change to this mode.

Commands relating to other topics that can be called in the Global configuration mode can

be found in the relevant sections.

You exit the Global configuration mode with the

end or exit command and are then in the

Privileged EXEC mode again.

4.1.2.1

plug

Description

With this command, you change to the Plug Configuration mode.

Requirement

You are in the Global Configuration mode.

The command prompt is as follows:

cli(config)#

Syntax

Call the command without parameters:

plug

Result

You are now in the Plug Configuration mode.

The command prompt is as follows:

cli(config-plug)#

Further notes

You exit the Plug Configuration mode with the end or exit command.

Siemens SCALANCE XM-400 Configuration Manual

Other manuals for Siemens SCALANCE XM-400