Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.2 IGMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
452 Configuration Manual, 06/2016, C79000-G8976-C252-11
8.2.3.14
no ip igmp query-max-response-time
Description
With this command you reset the period of time in an IGMP query that the client has to
respond to a query to the default value.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no ip igmp query-max-response-time
Result
The period of time is reset.
Further notes
You configure the time with the ip igmp query-max-response-time command.
You display the setting and other information with the
show ip igmp global-config
command.
8.2.3.15
ip igmp robustness
Description
With this command, you take into account the packet loss rate of a network..
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English