Siemens SCALANCE XM-400 Configuration Manual

Functions specific to SCALANCE
4.1 PLUG
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
145
4.1.3
Commands in the Plug configuration mode
This section describes commands that you can call up in the Plug Configuration mode.
In the Global Configuration mode, enter the
plug command to change to this mode.
● If you exit the Plug Configuration mode with the
exit command, you return to the Global
Configuration mode.
● If you exit the Plug Configuration mode with the
end command, you return to the
Privileged EXEC mode.
4.1.3.1
factoryclean
Description
With this command, you delete the device configuration stored on the PLUG.
Requirement
● There is a device configuration on the PLUG.
● You are in the Plug Configuration mode.
The command prompt is:
cli(config-plug)#
Syntax
Call the command without parameters:
factoryclean
Result
The device configuration on the PLUG is deleted.
4.1.3.2
write
Description
With this command, you format the PLUG and copy the current device configuration to it.
Requirement
● The PLUG is formatted.
● You are in the Plug Configuration mode.
The command prompt is:
cli(config-plug)#

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English