Siemens SCALANCE XM-400 - Show Ipv6 Ospf Route; Show Ipv6 Ospf Virtual-Links

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
574 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call the command without parameters:
show ipv6 ospf redundancy
Result
The OSPFv3 redundancy is shown.
9.3.1.10
show ipv6 ospf route
Description
This command shows the routes that were generated with OSPFv3.
Note
This command is available only w
ith layer 3.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ipv6 ospf route
Result
The routes are displayed.
9.3.1.11
show ipv6 ospf virtual-links
Description
This command shows an overview of the virtual connections of OSPFv3.
Note
This command is available only with layer 3.