Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.7 Port-based Network Access Control (Dot1X)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
876 Configuration Manual, 06/2016, C79000-G8976-C252-11
11.7.3.9
dot1x mac-auth port reset
Description
With this command, you reset MAC authentication for a port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x mac-auth port [mac <aa:aa:aa:aa:aa:aa>] reset
The parameters have the following meaning:
Parameter
Description
Range of values / note
mac
Keyword for a MAC address
-
aa:aa:aa:aa:aa:aa
MAC address of the interface
aa:aa:aa:aa:aa:aa
Result
MAC authentication is reset for the port.
11.7.3.10
dot1x mac-auth vlan-assign
Description
With this command you enable the assignment of the VLAN ID for a MAC address by the
RADIUS server.
The port can only be assigned to the VLAN, if the VLAN has been created on the device.
Otherwise Authentication is rejected.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English