Introduction
1.1 Information on the configuration manual (CLI)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
31
What's new as of version 6.0?
Below, you will find an overview of the most important function expansions:
● Information in the configuration limits
● Reset and Defaults > Profile
● Network structures > private VLANs
● Network protocols > DHCP server
● Layer 3 functions
– NAT (IPv4)
– PIM (IPv4)
– VRID tracking
– Interface tracking (VRRP)
● Configuration of IPv6 functionalities
– System Time > SNTP
– System Time > NTP
set in the factory
As of firmware version 6.0 the default user set in the factory "user" is no longer available
when the product ships.
If you update a device to the firmware V6.0 the default user set in the factory "user" is initially
s
till available. If you reset the device to the factory settings ("Restore Factory Defaults and
Restart") the default user set in the factory "user" is deleted.
You can create new users with the role "user".
Explanations of many of the specialist terms used in this documentation can be found in the
SIMATIC NET glossary.
You will find the SIMATIC NET glossary here:
● SIMATIC NET Manual Collection or product DVD
The DVD ships with certain SIMATIC NET products.
● On the Internet under the following address:
50305045 (http://support.automation.siemens.com/WW/view/en/50305045
)
To Next Page
Loading...
