Siemens SCALANCE XM-400 - Page 394

Network protocols
7.8 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
394 Configuration Manual, 06/2016, C79000-G8976-C252-11
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp access <GroupName> {v1|v2c|v3 {auth|noauth|priv}}
[read <ReadView|none>][write <WriteView|none>][notify <NotifyView|none>]
[{volatile|nonvolatile}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
GroupName
Name of the group to which access is
configured
max. 32 characters
Version Selects the version of the protocol
used
•
v1
•
v2c
•
v3
Authentication Selects the authentication method:
•
auth
enables MD5 or SHA as au-
thentication method
• noauth
no authentication
•
priv
enables authentication and
encryption
read
the data can be read
Keyword
•
ReadView
•
none
write
the data can be read and written
Keyword
•
WriteView
•
none
notify
Changes can be set as a tag
Keyword
•
NotifyView
•
none
Storage type specifies whether the settings remain
following a restart
•
volatile (volatile):
The settings are lost after a
restart
•
nonvolatile (non-volatile):
The settings are retained after
a restart
The keywords need to be specified.
If optional parameters are not specified when configuring a group, the default value will be
used.