Siemens SCALANCE XM-400 - Page 404

Network protocols
7.8 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
404 Configuration Manual, 06/2016, C79000-G8976-C252-11
Parameter
Description
Range of values / note
IPAddress
IPv4 address
Enter a valid IPv4 unicast address.
fqdn-name
Keyword for a domain name -
FQDN
Domain name (Fully Qualified Do-
main Name)
Maximum of 100 characters
ipv6
Keyword for an IPv6 address -
IP6-Address
IPv6 address
Enter a valid IPv6 address.
timeout
Keyword for the time the SNMP
agent waits for a response before it
repeats the inform request message
-
Seconds
Time in seconds
1 ... 1500
retries
Keyword for the maximum number of
attempts to obtain a response to an
inform request message
-
RetryCount
Number of attempts
1 ... 3
taglist
Keyword for tag list
-
TagIdentifier
Tag identifier that selects the desti-
nation address for SNMP.
Specify the tag identifier.
none
No tag identifier
-
volatile
nonvolatile
Specifies whether the settings re-
main following a restart.
•
volatile:
The default settings are used af-
ter a restart.
•
nonvolatile:
The saved settings are used af-
ter a restart.
port
Keyword for the port number at
which the SNMP manager receives
traps and inform messages
-
integer
Port number
1 ... 65535
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 42)".
If optional parameters are not specified when configuring, the default values apply.
Result
The SNMP target address is configured.
Further notes
You delete the SNMP target address with the no snmp targetaddr command.
You display the SNMP target address with the
show snmp targetaddr command.
You configure the SNMP target parameters with the
snmp targetparams command.
You display the SNMP target parameters with the
show snmp targetparam command.