Siemens SCALANCE XM-400 - Page 585

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
585
Syntax
Call up the command with the following parameters:
no area <Area-ID> range
<IPv6-Prefix> / <Prefix-Length>
[{
advertise | not-advertise
}]
[
cost <cost>
]
The parameters have the following meaning:
Parameter
Description
Range of values / note
AreaID
Area ID Specify the ID in the IPv4 address
format
x.x.x.x = 0 ... 255
0.0.0.0 = backbone area
IPv6-Prefix
IPv6 address
Enter a valid IPv6 address
Prefix-Length
Number of bits belonging to the prefix
(from left to right)
1 ... 128 bits
128: The node (host) itself
advertise
The address range is advertised outside the rang-
es.
-
not-advertise
The address range is not advertised to the outside.
-
cost
Keyword for the costs
-
value
Costs for the OSPF interface
1 ... 65535
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The address range is deleted.
Further notes
You configure the address range with the no area range command.
You configure the area with the
area command.
You can display the status of this function and other information with the
show ipv6 ospf
area-range
command.