Diagnostics
12.1 Event and fault handling
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
904 Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
The message when establishing a connection is
-
The message when a connection is down is disa-
bled
-
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select an interface, the function is disabled for all available interfaces.
The settings for monitoring the physical network connections have been configured.
You can display the current setting with the show events faults config command.
You enable the function with the
link command.
To Next Page
Loading...
