set system lockout
Enterasys C3 Configuration Guide 5-19
Usage
Once a read-write or read-only user account is locked out (that is, disabled), it can only be re-
enabled by a super user with the set system login command (page 5-6).
Super-user accounts are locked out only for a configured period of time.
If the default admin super user account has been locked out, and if the password reset button
functionality is enabled, you can press the reset button on the switch to re-enable the admin
account with its default values. The emergency-access user is restored as the default, the admin
account.
If the password reset button functionality has been disabled, you can wait until the lock out time
has expired or you can reboot the switch in order to re-enable the admin account.
Refer to “set system password-resetbutton” on page 5-10 for more information about password
reset button functionality.
Example
This example shows how to set failed login attempts to 5 and lockout time for super-users
accounts to 30 minutes:
C3(su)->set system lockout attempts 5 time 30
To Next Page
Loading...
