set ciscodp port
Enterasys C3 Configuration Guide 10-11
Parameters
Defaults
•Status: enabled
• Voice VLAN: none
• Trust mode: trusted
•CoS value: 0
Mode
Switch mode, read-write.
Usage
The following points describe how the Cisco DP extended trust settings work on the switch.
• A Cisco DP port trust status of trusted or untrusted is only meaningful when a Cisco IP phone
is connected to a switch port and a PC or other device is connected to the back of the Cisco IP
phone.
• A Cisco DP port state of trusted or untrusted only affects tagged traffic transmitted by the
device connected to the Cisco IP phone. Untagged traffic transmitted by the device connected
to the Cisco IP phone is unaffected by this setting.
• If the switch port is configured to a Cisco DP trust state of trusted (with the trusted yes
parameter of this command), this setting is communicated to the Cisco IP phone instructing it
to allow the device connected to it to transmit traffic containing any CoS or Layer 2 802.1p
marking.
status Sets the CiscoDP port operational status.
disable Does not transmit or process CiscoDP PDUs.
enable Transmits and processes CiscoDP PDUs.
vvid Sets the port voice VLAN for CiscoDP PDU transmission.
vlan-id Specifies the VLAN ID, range 1-4093.
none No voice VLAN will be used in CiscoDP PDUs. This is the default.
dot1p Instructs attached phone to send 802.1p tagged frames.
untagged Instructs attached phone to send untagged frames.
trusted Sets the extended trust mode on the port.
yes Instructs attached phone to allow the device connected to it to transmit
traffic containing any CoS or Layer 2 802.1p marking. This is the default
value.
no Instructs attached phone to overwrite the 802.1p tag of traffic
transmitted by the device connected to it to 0, by default, or to the value
configured with the cos parameter.
cos value Instructs attached phone to overwrite the 802.1p tag of traffic
transmitted by the device connected to it with the specified value, when
the trust mode of the port is set to untrusted. Value can range from 0 to
7, with 0 indicating the lowest priority.
port-string Specifies the port(s) on which status will be set.
To Next Page
Loading...
Need help?
General