clear lldp port tx-tlv
Enterasys C3 Configuration Guide 10-35
Parameters
Defaults
None.
Mode
Switch command, read-write.
all Disables all optional TLVs from being transmitted in LLDPDUs.
port-desc Disables the Port Description optional basic LLDP TLV from being
transmitted in LLDPDUs.
sys-name Disables the System Name optional basic LLDP TLV from being
transmitted in LLDPDUs.
sys-desc Disables the System Description optional basic LLDP TLV from being
transmitted in LLDPDUs.
sys-cap Disables the System Capabilities optional basic LLDP TLV from
being transmitted in LLDPDUs.
mgmt-addr Disables the Management Address optional basic LLDP TLV from
being transmitted in LLDPDUs.
vlan-id Disables the Port VLAN ID IEEE 802.1 Extensions TLV from being
transmitted in LLDPDUs.
stp Disables the Spanning Tree information defined by Protocol Identity
IEEE 802.1 Extensions TLV from being transmitted in LLDPDUs.
lacp Disables the LACP information defined by Protocol Identity IEEE
802.1 Extensions TLV from being transmitted in LLDPDUs.
gvrp Disables the GVRP information defined by Protocol Identity IEEE
802.1 Extensions TLV from being transmitted in LLDPDUs.
mac-phy Disables the MAC-PHY Configuration/Status IEEE 802.3 Extensions
TLV from being transmitted in LLDPDUs.
poe Disables the Power via MDI IEEE 802.3 Extensions TLV from being
transmitted in LLDPDUs. Only valid for PoE-enabled ports.
link-aggr Disables the Link Aggregation IEEE 802.3 Extensions TLV from being
transmitted in LLDPDUs.
max-frame Disables the Maximum Frame Size IEEE 802.3 Extensions TLV from
being transmitted in LLDPDUs.
med-cap Disables the LLDP-MED Capabilities TLV from being transmitted in
LLDPDUs.
med-pol Disables the LLDP-MED Network Policy TLV from being transmitted
in LLDPDUs.
med-loc Disables the LLDP-MED Location Identification TLV from being
transmitted in LLDPDUs.
med-poe Disables the LLDP-MED Extended Power via MDI TLV from being
transmitted in LLDPDUs. Only valid for PoE-enabled ports.
port-string Specifies the port or range of ports to be affected.