set snmp targetaddr
Enterasys C3 Configuration Guide 12-27
community strings will be accepted. This address configuration can be linked to optional SNMP
transmit parameters (such as timeout, retry count, and UDP port).
Syntax
set snmp targetaddr targetaddr ipaddr param param [udpport udpport] [mask mask]
[timeout timeout] [retries retries] [taglist taglist] [volatile | nonvolatile]
Parameters
Defaults
If not specified, udpport will be set to 162.
If not specified, mask will be set to 255.255.255.255
If not specified, timeout will be set to 1500.
If not specified, number of retries will be set to 3.
If taglist is not specified, none will be set.
If not specified, storage type will be nonvolatile.
Mode
Switch mode, read-write, when security profile = normal.
Switch mode, super-user, when security profile = C2.
Example
This example shows how to configure a trap notification called “TrapSink.” This trap notification
will be sent to the workstation 192.168.190.80 (which is target address “tr”). It will use security
and authorization criteria contained in a target parameters entry called “v2cExampleParams”. For
targetaddr Specifies a unique identifier to index the snmpTargetAddrTable.
Maximum length is 32 bytes.
ipaddr Specifies the IP address of the target.
param param Specifies an entry in the SNMP target parameters table, which is used
when generating a message to the target. Maximum length is 32 bytes.
udpport udpport (Optional) Specifies which UDP port of the target host to use.
mask mask (Optional) Specifies the IP mask of the target.
timeout timeout (Optional) Specifies the maximum round trip time allowed to
communicate to this target address. This value is in .01 seconds and the
default is 1500 (15 seconds.)
retries retries (Optional) Specifies the number of message retries allowed if a response is
not received. Default is 3.
taglist taglist (Optional) Specifies a list of SNMP notify tag values. This tags a location
to the target address as a place to send notifications. List must be enclosed
in quotes and tag values must be separated by a space (for example,
“tag 1 tag 2”).
volatile |
nonvolatile
(Optional) Specifies temporary (default), or permanent storage for SNMP
entries.
To Next Page
Loading...
Need help?
General