clear snmp engineid
12-42 SNMP Configuration
Defaults
None.
Mode
Switch command, read-write.
Usage
Changing the SNMP engine ID will cause all existing SNMP user configuration to be removed and
the switch to reset.
The default engine ID is defined per the standard as:
• First 4 octets — first bit = 1, the rest is IANA Enterprise number = 5624
• Fifth octet — set to 3 to indicate that a MAC address follows
• Last 6 octets — MAC address of the switch
Example
The following example resets the SNMP engine ID to the default value.
C3(su)->clear snmp engineid
All SNMP user configuration will be removed before resetting.
This command will reset the stack. Are you sure you want to continue? (y/n)y
Saving Configuration to stacking members
Resetting system ...
To Next Page
Loading...
