set policy profile
15-4 Policy Classification Configuration
Parameters
Defaults
If optional parameters are not specified, none will be applied.
Mode
Switch command, read-write.
profile-index Specifies an index number for the policy profile. Valid values are 1 - 255.
name name (Optional) Specifies a name for the policy profile. This is a string from 1 to
64 characters.
pvid-status
enable | disable
(Optional) Enables or disables PVID override for this profile. If all
classification rules associated with this profile are missed, then this
parameter, if specified, determines default behavior.
pvid pvid (Optional) Specifies the PVID to packets, if PVID override is enabled and
invoked as default behavior.
cos-status enable
| disable
(Optional) Enables or disables Class of Service override for this profile. If all
classification rules associated with this profile are missed, then this
parameter, if specified, determines default behavior.
Note: A maximum of 99 rules can be supported per policy profile for policy profiles
that have cos-status enabled.
cos cos (Optional) Specifies a CoS value to assign to packets, if CoS override is
enabled and invoked as default behavior. Valid values are 0 to 7.
egress-vlans
egress-vlans
(Optional) Specifies that the port to which this policy profile is applied
should be added to the egress list of the VLANs defined by egress-vlans.
Packets will be formatted as tagged.
forbidden-vlans
forbidden-vlans
(Optional) Specifies that the port to which this policy profile is applied
should be added as forbidden to the egress list of the VLANs defined by
forbidden-vlans. Packets from this port will not be allowed to participate in
the listed VLANs.
untagged-vlans
untagged-vlans
(Optional) Specifies that the port to which this policy profile is applied
should be added to the egress list of the VLANs defined by untagged-vlans.
Packets will be formatted as untagged.
append (Optional) Appends this policy profile setting to settings previously
specified for this policy profile by the egress-vlans,forbidden-vlans, or
untagged-vlans parameters.
If append is not used, previous VLAN settings are replaced.
clear (Optional) Removes this policy profile setting from settings previously
specified for this policy profile by the egress-vlans,forbidden-vlans, or
untagged-vlans parameters.
precedence
precedence-list
(Optional) Assigns a rule precedence to this profile. Lower values will be
given higher precedence. For a list of values, refer to the show policy
profile command output.
To Next Page
Loading...
Need help?
General