show policy capability
Enterasys C3 Configuration Guide 15-9
Mode
Switch command, read-only.
Usage
Use this command to display detailed policy classification capabilities supported by your
Enterasys C3 device. The output of this command shows a table listing classifiable traffic
attributes and the type of actions, by rule type, that can be executed relative to each attribute.
Above the table is a list of all the actions possible on this device.
The left-most column of the table lists all possible classifiable traffic attributes. The next two
columns from the left indicate how policy profiles may be assigned, either administratively or
dynamically. The next four columns from the left indicate the actions that may be performed. The
last three columns indicate auditing options.
An x in an action column for a traffic attribute row indicates that your system has the capability to
perform that action for traffic classified by that attribute.
Example
This example shows how to display the device’s policy classification capabilities. Refer to “set
policy rule” on page 15-10 for a description of the parameters displayed:
C3(su)->show policy capability
The following rules related to policy are supported in this device:
VLAN Forwarding Priority Permit
Deny Rules Table Rule-Use Notification
CosTable Longest Prefix Rules
=============================================================
| | D | | | | | F | | | D |
| | Y | | | | | O | S | | I |
| | N | A | | | | R | Y | | S |
| | A | D | V | | D | W | S | T | A |
| | M | M | L | C | R | A | L | R | B |
| | I | I | A | O | O | R | O | A | L |
| SUPPORTED RULE TYPES | C | N | N | S | P | D | G | P | E |
=============================================================
|MAC source address | | | | X | X | X | | | |
|MAC destination address | | | | X | X | X | | | |
|IPX source address | | | | | | | | | |
|IPX destination address | | | | | | | | | |
|IPX source socket | | | | | | | | | |
|IPX destination socket | | | | | | | | | |
|IPX transmission control | | | | | | | | | |
|IPX type field | | | | | | | | | |
|IPv6 source address | | | | | | | | | |
|IPv6 destination address | | | | | | | | | |
|IPv6 flow label | | | | | | | | | |
|IP source address | | | | X | X | X | | | |
|IP destination address | | | | X | X | X | | | |
|IP fragmentation | | | | | | | | | |
|UDP port source | | | | X | X | X | | | |
|UDP port destination | | | | X | X | X | | | |
|TCP port source | | | | X | X | X | | | |
|TCP port destination | | | | X | X | X | | | |
To Next Page
Loading...
