set policy rule
Enterasys C3 Configuration Guide 15-11
The following parameters apply to creating a traffic classification rule.
Defaults
None.
Mode
Switch command, read-write.
profile-index Specifies a policy profile number to which this rule will be assigned.
Policy profiles are configured with the set policy profile command as
described in “set policy profile” on page 15-3. Valid profile-index values
are 1- 255.
ether Specifies that the rule should apply to traffic with the specified type field
in Ethernet II packet.
ipproto Specifies that the rule should apply to traffic with the specified Protocol
field in IP packet.
ipdestsocket Specifies that the rule should apply to traffic with the specified
destination IP address with optional post-fixed TCP or UDP port.
ipsourcesocket Specifies that the rule should apply to traffic with the specified source IP
address, with optional post-fixed TCP or UDP port.
iptos Specifies that the rule should apply to traffic with the specified Type of
Service field in IP packet.
macdest Specifies that the rule should apply to traffic with the specified MAC
destination address.
macsource Specifies that the rule should apply to traffic with the specified MAC
source address.
tcpdestport Specifies that the rule should apply to traffic with the specified TCP
destination port.
tcpsourceport Specifies that the rule should apply to traffic with the specified TCP
source port.
udpdestport Specifies that the rule should apply to traffic with the specified UDP
destination port.
udpsourceport Specifies that the rule should apply to traffic with the specified UDP
source port.
data Specifies the code for the specified traffic classifier (listed above). This
value is dependent on the classification type entered. Refer to Table 15-3
for valid values for each classification type.
mask mask (Optional) Specifies the number of significant bits to match, dependent on
the data value entered. Refer to Table 15-3 for valid values for each
classification type and data value.
vlan vlan Specifies the action of the rule is to classify to a VLAN ID.
cos cos Specifies the action of the rule is to classify to a Class-of-Service ID. Valid
values are 0 - 4095. A value of -1 indicates that no CoS forwarding
behavior modification is desired.
drop | forward Specifies that packets within this classification will be dropped or
forwarded.
To Next Page
Loading...
