show ip irdp
Enterasys C3 Configuration Guide 26-15
Parameters
Defaults
If vlan vlan-id is not specified, IRDP information for all interfaces will be displayed.
Mode
Global configuration: C3(su)->router(Config)#
Exec mode: C3(su)->router#
Example
This example shows how to display IRDP information for the VLAN 1 interface:
C3(su)->router#show ip irdp vlan 1
Interface vlan 1 has router discovery enabled
Advertisements will occur between 450 and 600 seconds
Advertisements are sent with broadcasts
Advertisements are valid for 1800 seconds
Default preference will be 0
vlan vlan-id (Optional) Displays IRDP information for a specific VLAN. This VLAN
must be configured for IP routing as described in “Pre-Routing
Configuration Tasks” on page 24-1.
To Next Page
Loading...
