Enterasys C3 Configuration Guide 28-1
28
IPv6 Management
This chapter describes the switch mode set of commands used to manage IPv6.
Purpose
To enable or disable the IPv6 management function, to configure and display the IPv6 host
address and IPv6 gateway for the switch, and to display IPv6 status information.
Commands
show ipv6 status
Use this command to display the status of the IPv6 management function.
Syntax
show ipv6 status
Parameters
None.
For information about... Refer to page...
show ipv6 status 28-1
set ipv6 28-2
set ipv6 address 28-3
show ipv6 address 28-4
clear ipv6 address 28-4
set ipv6 gateway 28-5
clear ipv6 gateway 28-6
show ipv6 neighbors 28-7
show ipv6 netstat 28-7
ping ipv6 28-9
traceroute ipv6 28-10
To Next Page
Loading...
