Siemens SCALANCE XM-400 - Page 125

Configuration
3.4 Configuration Save & Restore
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
125
Parameter
Description
Range of values / note
cos-map
Shows the configuration settings of the
COS function
-
dscp-map
Shows the configuration settings of the
DSCP map function
-
output-rate-limit
Shows the configuration settings of the
output rate limit function
-
unicast-blocking
Shows the configuration settings of the
unicast blocking
-
ospf
Shows the configuration settings of the
Open Shortest Path First
-
vrrp
Shows the configuration settings of the
Virtual Router Redundancy Protocol
-
loopd
Shows the configuration settings of
loop detection
-
events
Shows the configuration settings of the
events
-
redundancy
Shows the configuration settings of the
redundancy
-
passive
Shows the configuration settings of
passive listening
-
umac
Shows the configuration settings of the
user configuration
-
nat
Shows the configuration settings of the
Network Address Translation
-
fmp
Shows the configuration settings of the
Fiber Monitoring protocol
-
pim
Shows the configuration settings of the
Independent Multicast protocol
-
router-
advertisement-
blocking
Shows the configuration settings of the
router advertisement blocking.
-
all
shows all configuration settings and all
default parameters. Some parameters
cannot be changed.
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The selected configuration settings of the device are displayed.