TC1796
System and Peripheral Units (Vol. 1 and 2)
User’s Manual V2.0, 2007-07
22-58, 22-59,
22-61
CAN_ID register is added.
22-60 Figure 22-24 is updated.
22-79 CPU write to LEC in last row of Table 22-7 is updated.
22-90 CAN Bus State for of NoBit and NewBit in Table 22-9 is corrected.
22-201 Configuration of CAN_FDR.DM for Equation (22.1) and
Equation (22.2) is updated.
Chapter 23 The functional description of the MLI , the module kernel description,
and operation the MLI module is completely reworked.
23-75, 23-76,
23-78
MLI0_ID and MLI1_ID registers are added.
23-3 Programmable baud rate in Section 23.1.1.1 is updated.
23-115 Register description of RPxBAR (x = 0-3) is updated.
23-129 Equation (23.6) is added.
23-142 Selected address range for AEN21 corrected.
24-31, 24-32,
24-33, 24-34
Figure 24-20, Figure 24-21, Figure 24-22, and Figure 24-23 are
updated.
24-61, 24-77 Cell Enabling on Event sections for GTC and LTC are updated.
24-76 Header of Table 24-4 is updated.
24-150,
24-151,
24-154
GPTA0_ID and GPTA1_ID registers are added.
24-233,
24-235
LTCA2_ID register is added.
24-125,
24-131
Section 24.2.6.3 “Check_Input()” and Section 24.2.6.6
“Manage_Mux()“ are updated.
24-253 Table 24-26 is updated.
24-263 Figure 24-91 is updated.
24-266 Attention paragraph at the bottom is updated.
25-9 Equation (25.1) is updated.
25-37 The reference voltage Section 25.1.5 is updated.
TC1796 User’s Manual
Volume 1 (of 2) System Units & Volume 2 (of 2) Peripheral Units
Revision History: V2.0, 2007-07
To Next Page
Loading...
Need help?
General