www.ti.com
Revision History
2203
SPNU563A–March 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
Revision History
expressed as a percentage (%) of the reference period ........................................................................ 1118
• Chapter 24: High-End Timer Transfer Unit (HTU) Module .................................................................. 1131
• Section 24.2: Updated third bullet in fifth paragraph. Added per request ..................................................... 1134
• Section 24.2: Added fourth bullet in fifth paragraph.............................................................................. 1134
• Section 24.2.4.1: Updated first sentence in third paragraph .................................................................... 1141
• Section 24.2.4.1: Updated fourth sentence in seventh paragraph. If the signal frequency would increase, then a wrong
pair [22,23] could be read ........................................................................................................... 1142
• Section 24.2.5: Updated second paragraph....................................................................................... 1143
• Figure 24-13: Changed position of third rising edge in waveform.............................................................. 1145
• Table 24-24: Corrected bit range of the Reserved bit to 31-10 and the INTTYPE0 bit to 9-8.............................. 1158
• Table 24-25: Corrected bit range of the Reserved bit to 31-10 and the INTTYPE1 bit to 9-8.............................. 1159
• Figure 24-31: Changed 2 LSBs to 0 ............................................................................................... 1164
• Table 24-31: Updated Description of STARTADDRESS1 bit. Added last sentence......................................... 1164
• Figure 24-32: Changed 2 LSBs to 0 ............................................................................................... 1164
• Table 24-32: Updated Description of ENDADDRESS1 bit. Added last sentences........................................... 1164
• Figure 24-40: Changed 2 LSBs to 0 ............................................................................................... 1173
• Table 24-40: Updated Description of STARTADDRESS0 bit. Added last sentence......................................... 1173
• Figure 24-41: Changed 2 LSBs to 0 ............................................................................................... 1173
• Table 24-41: Updated Description of ENDADDRESS0 bit. Added last sentences........................................... 1173
• Section 24.5.7: Updated paragraph ................................................................................................ 1180
• Table 24-49: Corrected table title................................................................................................... 1180
• Chapter 25: General-Purpose Input/Output (GIO) Module .................................................................. 1183
• Section 25.2: Corrected register names in second paragraph to GIOOFF1 and GIOOFF2................................ 1185
• Figure 25-3: Moved figure location. Subsequent figures renumbered......................................................... 1187
• Section 25.3.1: Changed description of Data direction in first bullet........................................................... 1187
• Section 25.3.1: Changed description of Open drain in sixth bullet............................................................. 1187
• Section 25.3.1: Changed description of Pull select in eighth bullet ............................................................ 1188
• Section 25.4.2: Changed last sentence............................................................................................ 1190
• Section 25.5.1: Chnaged third sentence........................................................................................... 1192
• Section 25.5.2: Changed paragraph ............................................................................................... 1193
• Section 25.5.3: Changed paragraph ............................................................................................... 1194
• Section 25.5.4: Changed paragraph ............................................................................................... 1195
• Section 25.5.4.1: Changed NOTE. Deleted first sentence ...................................................................... 1195
• Section 25.5.5: Changed paragraph ............................................................................................... 1197
• Section 25.5.5: Added NOTE ....................................................................................................... 1197
• Section 25.5.6: Added second sentence .......................................................................................... 1200
• Figure 25-12: Updated Read/Write value of bits to R/W1C-0................................................................... 1200
• Figure 25-12: Updated LEGEND to include W1C ................................................................................ 1200
• Table 25-22: Changed Pull Control = Enabled when device is under reset .................................................. 1209
• Chapter 26: FlexRay Module...................................................................................................... 1210
• Figure 26-30: Updated figure to include where interrupts are sent ............................................................ 1270
• Figure 26-31: Updated title .......................................................................................................... 1272
• Section 26.3.1.12: Updated register bit names to reflect corresponding message buffer number......................... 1288
• Table 26-30: Combined Transfer to System Memory Occurred (TSMO[1-4]) Field Descriptions tables into a single
table .................................................................................................................................... 1289
• Section 26.3.1.13: Updated register bit names to reflect corresponding message buffer number......................... 1290
• Table 26-31: Combined Transfer to Communication Controller Occurred (TCCO[1-4]) Field Descriptions tables into a
single table............................................................................................................................. 1291
• Section 26.3.1.16: Corrected NOTE ............................................................................................... 1294
• Figure 26-56: Corrected register bit name for bits 10-8 and bits 6-4 .......................................................... 1297
• Figure 26-57: Corrected register bit name for bits 10-8 and bits 6-4 .......................................................... 1298
• Section 26.3.1.19: Updated register bit names to reflect corresponding message buffer number......................... 1299
• Section 26.3.1.20: Updated register bit names to reflect corresponding message buffer number......................... 1303
• Section 26.3.1.21: Updated register bit names to reflect corresponding message buffer number......................... 1307
To Next Page
Loading...
