Huawei Quidway S8500 Series - Local-User Password-Display-Mode

Command Manual – System Management
Quidway S8500 Series Routing Switches Chapter 1 File System Management Commands
Huawei Technologies Proprietary
1-25
Parameter
username: User name.
all [ service-type { ftp | lan-access | telnet | ppp | ssh | terminal } ]: Deletes all local
users. The keywords ftp, lan-access, telnet are used respectively to delete all the FTP,
LAN access, Telnet local users. ppp is used to delete all the point-to-point access local
views. The SSH parameter is used to delete all the SSH local views. And the terminal
parameter is used to delete all the user terminals.
multicast [ domain domain-name ]: Adds or deletes multicast address.
ipaddress: Multicast IP address.
password-display-mode { auto | cipher-force }: Specifies the display mode of
password. auto indicates the password will be displayed in the same mode as that
used when the user configure the password. And cipher-force indicates the password
will be displayed in forcible cipher mode.
Description
Use the local-user command to configure a local user and enter the local user view.
Use the undo local-user command to cancel one or all the local users.
By default, no local user exists.
This configuration is required if you want to access FTP server through FTP from a
client.
Example
# Create a local user, and enter the local user view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] local-user quidway
[Quidway-luser-quidway]
1.3.7 local-user password-display-mode
Syntax
local-user password-display-mode { auto | cipher-force }
undo local-user password-display-mode
View
System view