Huawei Quidway S8500 Series - Display Egress Counter

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 7 Port Packet Statistics Commands
Huawei Technologies Proprietary
7-2
After you user the set egress counter command to set the monitoring mode of a card,
the counters will be automatically reset.
By default, a card does not implement egress packet statistics.
Related command: display egress.
Note that:
z You cannot configure ports as the objects to be monitored by the egress packet
statistics counters on GV48D, GT24D, GP24D, XP4B and XP4CA cards.
z This command does not support egress packet statistics on POS ports not bound
to a VLAN.
z After successful configuration, it is necessary to reset the counters to start
counting again.
Example
# Set the egress packet statistics mode of Counter 0 on slot 4 so that it monitors port
GigabitEthernet4/1/1.
[Quidway] set egress counter0 slot 4 interface GigabitEthernet4/1/1
7.1.2 display egress counter
Syntax
display egress { counter0 | counter1 } slot slot-num [ clear ]
View
Any view
Parameter
counter0: Counter 0, used for packet statistics monitoring.
counter1: Counter 1, used for packet statistics monitoring.
slot-num: Card slot number.
clear: Clears the counting data after a counter is read.
Description
Use the display egress command to display egress packet statistics information and
the monitoring objects of a counter. To clear the counter data, include the parameter
clear in the command.
Related command: set egress counter.
Example
# Query the egress packet statistics information of slot 4, and then clear the counter.
[Quidway] display egress counter0 slot 4 clear