Huawei Quidway S8500 Series User Manual

Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 4 RPR Port Configuration Commands
Huawei Technologies Proprietary
4-24
Note that two nodes’ bridge MAC addresses cannot be the same on the ring. Here both
Ringlet0 and Ringlet1 refer to sending sub-rings.
Example
# Transport data packets to the destination node with MAC address 0001-0002-0003
over ringlet0, and transport data packets to the destination node with MAC address
0001-0002-0004 over ringlet1.
<Quidway> system-view
[Quidway] interface RPR2/1/1
[Quidway-RPR2/1/1] rpr static-rs 0001-0002-0003 ringlet0
[Quidway-RPR2/1/1] rpr static-rs 0001-0002-0004 ringlet1
4.1.23 rpr station-name
Syntax
rpr station-name string
undo rpr station-name string
View
RPR logical port view
Parameter
string: Station name, a string consisting of up to 20 characters.
Description
Use the rpr station-name command to configure a station name.
Use the undo rpr station-name command to remove the configuration.
Example
# Name the local station “hangzhou”.
<Quidway> system-view
[Quidway] interface RPR2/1/1
[Quidway-RPR2/1/1] rpr station-name hangzhou
4.1.24 rpr timer
Syntax
rpr timer { atd value | fdd value | holdoff value | stability value | tp-fast value |
tp-slow value | tc-fast value | tc-slow value | wtr value }
undo rpr timer { atd | fdd | holdoff | stability | tp-fast | tp-slow | tc-fast | tc-slow |
wtr}

Huawei Quidway S8500 Series Specifications

General

Brand	Huawei
Model	Quidway S8500 Series
Category	Switch
Language	English