Command Manual – Port
Quidway S8500 Series Routing Switches Chapter 4 RPR Port Configuration Commands
Huawei Technologies Proprietary
4-11
Field Description
Protection start time on the east span Protection start time on the east span
Protection start time on the west span Protection start time on the west span
4.1.7 display rpr rs-table
Syntax
display rpr rs-table [ overall | static | dynamic | vrrp ] [ rprpos [ interface-number ] ]
View
Any view
Parameter
overall: Integrated ring selection tables, which guide field programmable gate array
(FPGA) to select rings.
static: Static ring selection tables. You can create them manually. Their priority is
higher than that of dynamic ring selection tables.
dynamic: Dynamic ring selection tables. Topology databases can calculate them
according to the shortest path.
vrrp: VRRP (virtual router redundancy protocol) ring selection tables, which consist of
MAC ring selection entries from integrated ring selection tables when VRRP is
supported.
interface-number: RPR port number, in the format of slot number/card number/port
number.
If no parameter is specified, the command displays integrated ring selection tables of all
RPR rings.
Description
Use the display rpr rs-table command to display integrated ring selection table
information. Integrated ring selection tables, which are written in CAM (conditional
access module) of the FPGA finally, are generated from static and dynamic ring
selection tables, For the same destination node, the system selects rings according to
the existing static ring selection information. Otherwise, the system selects rings
according to the dynamic ring selection information.
Example
# Display dynamic ring selection tables.
[Quidway] display rpr rs-table dynamic rpr2/1/1
Dynamic Ring Selection Table of rpr2/1/1
To Next Page
Loading...
Need help?
General